Testing the compressor in a freezer or fridge involves a few steps, but it's important to note that handling electrical components and refrigerant can be dangerous. If you're not comfortable or experienced with appliance repairs, it's recommended to seek the assistance of a professional technician. Here's a general guide for testing the compressor:
Tools and Equipment Needed:
-
Multimeter
-
Screwdriver
-
Insulated gloves and safety goggles
Steps:
1. Safety First:
-
Ensure the appliance is unplugged before you start any testing. Safety should be the top priority.
2. Locate the Compressor:
-
The compressor is usually located at the back of the refrigerator or freezer. It's a black, dome-shaped component with metal tubes connected to it.
3. Inspect the Compressor:
-
Look for any obvious signs of damage, such as oil leaks or burnt areas. If you see any issues, the compressor may need to be replaced.
4. Resistance Check:
-
Use a multimeter to measure the resistance of the compressor terminals. Set the multimeter to the ohms (Ω) setting. Identify the three terminals (start, run, and common) on the compressor.
-
Measure the resistance between:
-
Start and Run terminals
-
Start and Common terminals
-
Run and Common terminals
-
-
-
Refer to the appliance's service manual or technical documentation for the expected resistance values. If the readings are significantly different from the specified values, the compressor may be faulty.
5. Continuity Check:
-
Perform a continuity check by setting the multimeter to the continuity (beep) setting. Check for continuity between each terminal and the compressor case. There should be no continuity between the terminals and the case. If there is continuity, the compressor may have a ground fault and needs replacement.
6. Start Relay and Overload Testing:
-
The start relay and overload protector are connected to the compressor. Test these components using the multimeter to ensure they are functioning correctly. A faulty relay or overload can prevent the compressor from starting.
7. Listen and Observe:
-
Plug in the appliance and listen for any unusual noises coming from the compressor. A humming sound followed by a click may indicate an issue. Additionally, observe if the compressor is vibrating, indicating that it's trying to start.
8. Temperature Check:
-
Touch the compressor while it's running (use insulated gloves). It should feel warm but not excessively hot. If it's extremely hot, it may be overheating, and there could be a problem.
9. Consult a Professional:
-
If you are unable to identify the issue or if any of the tests indicate a problem, it's advisable to consult a professional technician for a more comprehensive diagnosis and repair.