How to Replace Range/Stove/Oven Solid Surface Element?

1. Shut off power:
   Turn off the power to the range by flipping the circuit breaker or unplugging the power cord for safety.

2. Clear the workspace:
   Remove any cookware from the surface element area to improve access.

3. Locate mounting screws:
   Look for mounting screws around the edge of the solid element underside.

4. Remove mounting screws:
   Using a nut driver or screwdriver, remove the mounting screws to detach the element from the cooktop.

5. Lift out the old element:
   Carefully lift out the old element. It may stick slightly due to years of use, so wiggle it gently as needed.

6. Clean the cooktop:
   Clean the underside of the cooktop if it is greasy or dirty to prepare for a new seal.

7. Install the new element:
   Set the new element in place, aligning the screw holes if present. Tighten the screws, but avoid overtightening.

8. Reconnect wire leads:
   Reattach the wire leads by squeezing the terminals with pliers to lock them into place.

9. Restore power and test:
   Turn the power back on and test the element by monitoring its temperature rise.

10. Replace cookware:
    Replace any cookware and enjoy your newly replaced solid surface element!

By following these steps, you can effectively replace the solid surface element in your range or stove, ensuring safe and proper operation.

If the solid surface burner is not functioning, it is likely that the element has burned out. Similar to other burners, the element contains a heating element that glows hot when electricity is applied. This heat is then transferred to the solid surface above it. Over time, elements can burn out, much like lightbulbs. If the solid element is not working and electricity cannot pass through it, it will need to be replaced. Follow the provided instructions to safely remove and replace the element. Burnt out elements cannot be repaired, so replacing it will restore proper heating functionality.