Stove/Oven Control Board
      Back to home
      1. UpFix FAQ's
      2. Appliance
      3. Stove/Oven Control Board

      Gas Stove Burners Spark All the Time?

      Troubleshooting and Solutions

      If your gas stove burners spark continuously, it can be an annoying and potentially dangerous issue. Here are some common reasons for this problem and steps to troubleshoot and fix it:

      Common Causes

      1. Moisture or Spills:

        • Moisture or food spills on the igniter or burner can cause continuous sparking.

      2. Faulty Igniter Switch:

        • The igniter switch might be stuck or malfunctioning, causing it to spark continuously.

      3. Short Circuit in Wiring:

        • There might be a short circuit in the wiring, causing the igniters to receive continuous power.

      4. Defective Spark Module:

        • The spark module, which controls the igniters, might be defective.

      Troubleshooting Steps

      1. Dry the Igniter and Burners:

        • Turn off the stove and unplug it from the electrical outlet or turn off the circuit breaker.
        • Remove the burner grates and caps.
        • Use a towel or cloth to dry the igniters and burners thoroughly. Make sure there is no moisture or residue left.
        • Allow the stove to air dry for a few hours before testing it again.

      2. Clean the Igniter and Burners:

        • Inspect the igniters for any food debris or spills that might be causing the continuous sparking.
        • Use a toothbrush or a small brush to clean the igniters and burner ports.
        • Ensure that the igniters and burner ports are free of any obstructions.

      3. Check the Igniter Switches:

        • Turn off the stove and unplug it from the electrical outlet or turn off the circuit breaker.
        • Access the igniter switches by removing the control knobs and the control panel.
        • Inspect the igniter switches for any signs of damage or sticking. If a switch is stuck, try to free it gently.
        • If any of the igniter switches are damaged or malfunctioning, they will need to be replaced.

      4. Inspect the Wiring:

        • Check the wiring connected to the igniters and igniter switches for any signs of damage or short circuits.
        • Ensure all connections are tight and secure.
        • Repair or replace any damaged wiring as necessary.

      5. Test the Spark Module:

        • If the igniter switches and wiring are in good condition, the spark module might be the issue.
        • Turn off the power to the stove and unplug it.
        • Locate the spark module (usually found behind the control panel or at the back of the stove).
        • Use a multimeter to test the spark module for continuity. If there is no continuity, the spark module might be defective and need replacement.

      Additional Solutions

      If you identify that the issue is related to a control board or other electronic components, consider sending your faulty control board to UpFix for repair. UpFix offers repair services that can save you up to 80% compared to buying a new component, while also supporting an eco-friendly service by reducing electronic waste.

      Safety Reminder

      If you are unable to fix the issue yourself or if you smell gas, it’s crucial to contact a professional technician immediately. Do not attempt to use the stove until the problem has been resolved.

      For a cost-effective and eco-friendly solution, send your faulty control board to UpFix for repair and save up to 80%! Visit UpFix.com for more details.